Blogs about: Eompls
Featured Blog
AToM Tunnel Selection Using MPLS Traffic-Engineering
By default, AToM will use IGP to select what path that will used to send the pseudowire packets. In this scenario we will use MPLS Traffic-Engineering to select the pseudowire path. Below is the diagr… more →
irwan piesessa
GNS3 Lab: Any Transport over MPLS (AToM) basic configuration for Ethernet 802.1q and Frame-relay
— 2 comments
pierky wrote 19 hours ago: AToM stands for Any Transport over MPLS, a quite reassuring technology which, provided you have a MP … more →
Trunking and sub-interfaces on the same switchport
— 2 comments
DataPlumber wrote 1 year ago: For some reason, I never knew that you could trunk and use a sub-interface on the same port of a Cat … more →
Cisco CCIE Project Part 3 - Configure EoMPLS Pseudowire
timsteiner wrote 1 year ago: Cisco EoMPLS Pseudowire configuration This document provides step-by-step instructions for setting u … more →
Cisco CCIE Project - EoMPLS Pseudowire over ATM
timsteiner wrote 1 year ago: The following 5 part series provides detailed instructions on how to set up a pseudowire over multip … more →
AToM Tunnel Selection Using MPLS Traffic-Engineering
— 2 comments
irwanp wrote 1 year ago: By default, AToM will use IGP to select what path that will used to send the pseudowire packets. In … more →
Revealing AToM (Any Transport over MPLS) Packets
irwanp wrote 1 year ago: AToM is used to transport any layer 2 packet via MPLS cloud. This MPLS application is used two MPLS … more →
